Kyosho Mini Inferno Alloy Rear Arm Bulk for Front Gearbox MIF008R by GPM  [MIF008R]

Alloy rear arm bulk for Mini Inferno front gearbox

This aftermarket alloy rear arm bulk is an RC-scale replacement part made for Kyosho Mini Inferno platforms. It mounts at the front gearbox location and is supplied as a single 1pcs unit with the mounting screws noted in the product title.

Fitment only covers the Mini Inferno family referenced in the title, so verify your exact chassis code before purchase. The component is machined from an aluminium alloy to give greater durability than the factory plastic piece while preserving correct gearbox alignment.

Installation is straightforward for modellers familiar with routine maintenance; the part replaces the original rear arm bulk at the front gearbox and secures with the supplied fasteners. Keep original bearings and shafts where applicable and recheck gear mesh and clearances after fitting to avoid binding.

On setup and tuning the stiffer alloy bulk can change steering and suspension response by making the mounting point firmer; use this upgrade where sustained durability and consistent geometry are priorities, such as practice runs or event sessions.