Kyosho Mini Inferno NB16 Rear Suspension Arm - Blue - MIF-032/BU by 3Racing  [MIF-032/BU]

Rear arm for Mini Inferno NB16 tuning

This blue rear suspension arm fits Kyosho Mini Inferno ACME NB16 Racing setups and is supplied in the finish shown in the title. It replaces the factory rear arm and gives a straightforward way to tweak rear geometry and linkage response on 1/10-scale Mini Inferno chassis.

Installation notes: remove the old arm and refit this unit using the vehicle's existing mounting points, check screw lengths and pivot alignment during reassembly, and ensure ball stud and hinge pin clearances are correct before running. No specialist tools are needed beyond standard hex drivers and pliers used for Mini Inferno servicing.

Tuning role: swapping the rear arm changes roll center and rear track behavior, making it useful when refining corner bite, throttle transition, or restoring handling after wear. Make small changes to rear geometry and test progressively on a controlled track to find the best balance between understeer and oversteer.