Kyosho Inferno MP 7.5 Front Lower Arm Lock Plate 4mm Alloy MP7508F by GPM  [MP7508F]

4mm alloy lower arm lock plate for Kyosho MP7.5

This aftermarket 4mm alloy lower arm lock plate is made to fit the Kyosho Inferno MP 7.5 front gearbox assembly and is supplied as 1pc. The thicker alloy plate replaces the factory lower arm lock plate to cut down flex at the mounting point and give a firmer connection between the lower arm and gearbox housing.

Installation is straightforward for hobbyists familiar with MP7.5 maintenance: remove the original lower arm lock plate from the front gearbox, line up the alloy plate with the same mounting points, and secure it using the existing fasteners from your kit. After fitting, check alignment and full suspension travel to confirm there is no binding.

Used as a tuning item, the alloy plate helps stabilise the lower arm pivot under load and can make steering response more consistent on high-grip surfaces and during harder cornering. This part is intended as an RC-scale upgrade for setup adjustments and improved durability on the Kyosho Inferno MP 7.5 front assembly.