Kyosho IF553 MP10e Receiver Box Kit - Durable Sealed Case  [KY-IF553]

Kyosho IF553 - Receiver Box Set (MP10e)
Price:
CAD$8.87
Brand:
Kyosho
Model:
KY-IF553
Condition:
Brand New
Quantity Discount
Unit Price You Save
2 $7.87 each $2.00 or 11%
3+ $7.48 each $4.17 or 16%
Write a review

Protect Electronics with the Kyosho IF553 Receiver Box Kit

The Kyosho IF553 Receiver Box Kit is built for the Inferno MP10e series and gives a tough, weather-resistant home for your car's electronics. It helps keep dust and splash out of sensitive components so your radio gear and servos keep performing under rough bashing sessions. The snug fit and sturdy materials suit racers and club drivers who need reliable protection on loose tracks.

Designed Specifically for the MP10e Chassis

Because the Kyosho IF553 matches the MP10e layout, it installs cleanly and keeps wiring tidy inside the chassis. Its construction reduces the chance of moisture intrusion and lowers the risk of signal issues caused by stray debris. That makes it a practical choice for those running competitive or weekend off-road setups.

Simple Installation Tips for Long-Term Reliability

Fit the IF553 carefully and check that all seals and mounting points are flush to maximise dust and moisture resistance. Place the receiver to avoid interference with battery and motor wiring, and inspect the seals after heavy use to keep performance consistent.

Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.
The IF553 is made to the MP10e layout and may need trimming or brackets to fit earlier MP10 versions. Try test-fitting before committing to glue or screws.
Leave a small vent gap where practical or use low-power receivers that run cooler. Avoid packing the box tightly with heat-generating components.
Use the stock fixings where possible and rubber grommets to isolate the box from chassis vibration. Short machine screws that do not compress the seal work best.

Copyright © 2008-2026 rcjaz.ca All rights reserved