Kyosho GAB2303 Gensace LiPo 1950mAh 11.1V 30C Pack (XT60H-F)  [KY-GAB2303]

Kyosho GAB2303 - Gensace LiPo 1950mAh (30C/11.1V/??????/XT60H-F)
Price:
CAD$0.00
Brand:
Kyosho
Model:
KY-GAB2303
GTIN:
4548565525744
Write a review

Compact 11.1V LiPo for 1/10 and 1/8 electric RCs

The Kyosho GAB2303 Gensace LiPo 1950mAh is built for hobby-grade electric models that require an 11.1V supply and an XT60H-F discharge connector. Key electrical details are listed: nominal voltage 11.1V, capacity 1950mAh, and a 30C continuous discharge rating, which indicate expected runtime and voltage behavior under load while not specifying cell count or physical dimensions.

Fitting this pack is straightforward on chassis that accept 11.1V batteries and an XT60H-F plug; always confirm battery bay clearance and connector orientation before final installation. Use the vehicle's strap or a low-compression bracket to secure the pack and route the lead clear of moving suspension and drivetrain components.

Tuning with this battery focuses on practical handling changes rather than outright power gains: the 1950mAh capacity balances run time against weight for sprint sessions, and the 30C rating gives reasonably predictable voltage sag under moderate loads. Adjusting the pack placement in the chassis will shift front-to-rear balance and can be used to fine-tune handling without altering mechanical setup.

Follow standard LiPo charging and care: use a compatible LiPo charger and balance-charge routines where available, store at the recommended storage voltage, and inspect the pack for swelling or damage before and after use. Do not attempt to repair damaged cells and follow local regulations for safe disposal.

Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.
The pack uses an XT60H-F discharge connector. Match that connector to your ESC input, confirm correct polarity before applying power, and secure the cable to prevent it from being pulled during running.
Functionally it can replace other 11.1V packs if the connector, capacity, and physical fit are compatible. Always verify battery bay dimensions and the effect on weight distribution before making the swap.
Use a LiPo-capable charger, select the correct cell count for an 11.1V pack (3S), and apply balance charging when possible. Charge at a conservative current if you are unsure of the pack history.
The 1950mAh capacity and 30C rating affect vehicle mass and voltage under load; moving the pack location will shift balance and can noticeably alter throttle response and cornering feel.

Copyright © 2008-2026 rcjaz.ca All rights reserved