The Kyosho FW-06 Aluminum One Way Hub is an alloy replacement built to fit Kyosho FW-06 layouts and add a firmer connection between the wheel hub and differential assembly. This aluminum unit changes how drive torque is handed to the axle during acceleration and corner exits, making throttle inputs feel more direct.
Fitting follows the standard one way hub procedure for the FW-06: remove the stock hub, install the aluminum part, confirm proper seating and thread engagement, and check clearance around suspension and steering components. Typical hex drivers and wheel nut tools are sufficient; refer to your chassis manual for recommended torque settings to avoid over-tightening.
Tuning note: moving to an aluminum hub raises mechanical stiffness and can alter traction and throttle response. Use this change alongside diff preload, slipper or clutch adjustments, and motor/ESC braking tuning to match the new drivetrain feel. Inspect mating surfaces for wear and re-check fasteners after the first runs.
Intended as a tuning component for scale on-road setups, this aluminum one way hub offers a stiffer hub interface for Kyosho FW-06 chassis and should be adjusted into a full drivetrain setup.
Copyright © 2008-2026 rcjaz.ca All rights reserved
