Kyosho FW-06 Front and Rear Center Shaft FW06-13 by 3Racing  [FW06-13]

Kyosho FW-06 Front + Rear Center Shaft - 3RACING FW06-13
Price:
CAD$21.50
Brand:
3Racing
Model:
FW06-13
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Replacement center shaft details

This replacement center shaft is built for the Kyosho FW-06 chassis and carries the part number FW06-13. It fits as a direct replacement for worn stock shafts and preserves existing drivetrain geometry for easy maintenance.

Practical advice for hobbyists: confirm the FW-06 layout before fitting, check drive cups and dogbones for wear, and follow safe removal and reassembly steps to keep drivetrain alignment correct. This component supports routine servicing and setup tuning rather than claiming performance gains.

Specifications

  • Item: Front + Rear Center Shaft
  • Material: Not specified
  • Model Number: FW06-13
  • Compatibility: Kyosho FW-06

Use this center shaft to replace factory parts on FW-06 vehicles and restore correct drivetrain alignment for reliable tuning and maintenance.

How do I confirm this shaft will fit my FW-06?

Measure the current shaft and compare the model FW06-13 dimensions to your stock part, and check spline and coupling interfaces before final installation.

Should I replace drive cups when fitting this shaft?

Inspect drive cups and dogbones for wear; reuse if in good condition or replace to avoid fitment issues and drivetrain play.

Will installing FW06-13 change gear ratios?

No, the shaft restores the original geometry and does not alter gearing. Any handling differences usually come from related worn parts or setup changes.

Any tips to avoid binding after install?

Tighten fasteners to the correct torque, check dogbone alignment, and rotate the drivetrain by hand to confirm smooth operation before running.

Copyright © 2008-2026 rcjaz.ca All rights reserved