KYOSHO FW05-R/FW05RR Anti-Roll Bar Link Ends FW05-008A by 3Racing  [FW05-008A]

Link end fittings for KYOSHO FW05-R and FW05RR

This set supplies male and female anti-roll bar end fittings designed to fit KYOSHO FW05-R and FW05RR touring chassis. The parts act as the interface between the sway bar and suspension linkage, matching the original attachment geometry while letting you swap worn ends or try a different linkage setup quickly.

The focus here is fitment and tuning: these rod ends are intended for model suspension adjustment only and are not suitable for full-size vehicles. Use them to fine-tune how roll force is shared between left and right wheels during cornering.

Fitting tips: remove the wheel if necessary and loosen the linkage to reach the roll bar ends, check existing fasteners and wear before replacing, then attach the male and female ends to the correct bar or rod. Cycle the suspension by hand to confirm clearance through full travel before final tightening. Apply threadlock only where the chassis manual recommends it.

Tuning note: swapping these ends changes how load is passed into the suspension and can subtly shift understeer/oversteer balance. Make small adjustments and test with laps to judge handling effects.