KYOSHO Fazer Mk2 FZ02 Front and Rear Wheel Shafts JR-KFZ202-LB by Jazrider  [JR-KFZ202-LB]

Detailed shaft description for Fazer Mk2

This is an RC-scale front and rear wheel shaft set made for the KYOSHO Fazer Mk2 FZ02 chassis, supplied as two blue anodized aluminum pieces as stated in the product title. The item replaces original wheel shafts where stock parts are plastic or lower-grade metal, offering a direct metal substitute intended for improved consistency in wheel retention.

Fit these shafts when lateral play and wheel alignment affect handling. The component is a chassis-level replacement; verify the FZ02 designation on your Fazer Mk2 before installing. It is compatible with Fazer vehicles that specifically use the FZ02 wheel shaft pattern referenced in the product name.

Installation is workshop-suitable: remove wheel and hub, swap the factory shaft for the replacement, then reassemble while checking wheel runout and bearing alignment. Use the correct hex driver size and avoid over-torquing to prevent bearing preload or hub damage. Recheck fastener torque after initial runs to ensure the fit stays secure.