This aluminum rear upper suspension arm set is an RC-scale replacement part intended for Kyosho Fazer Mk2 FZ02 chassis use. Built as a direct-fit hop-up, the set replaces standard rear upper arms to reduce flex in critical suspension linkages and provide a firmer mounting point for suspension geometry adjustments.
Installation is straightforward on compatible Fazer Mk2 FZ02 assemblies: remove the rear wheel hub and rear arm fasteners, swap the stock arms with these aluminum pieces, and secure with the original hardware. Use the correct hex driver and check pivot pin alignment during reassembly to ensure smooth movement of the suspension.
On tuning: swapping to aluminum upper arms changes the way the rear suspension reacts to inputs, typically giving crisper camber response and a more direct feel during cornering on paved or indoor track surfaces. When fitting, verify wheel toe and camber after installation and re-check for binding before each run. This product is intended only for 1:10 on-road RC use and not for full-scale vehicles.
Copyright © 2008-2026 rcjaz.ca All rights reserved
