Kyosho FAT305BK Front Drift Wheels 14-Spoke Black 24mm Pair  [KY-FAT305BK]

Front drift wheel overview and fitment

This front wheel pair is built for 1/10 on-road drift chassis and supplied as two pieces. The 14-spoke black wheels offer a 24mm effective tread width and are designed for slip-style drift tyre application, focusing on practical mounting and front-end setup used by drifters.

• Compatibility: Made to fit typical 1/10 on-road drift cars and hubs that accept standard drift wheel adapters.
• Included: Two front wheels, sold as a pair for left and right fitment.
• Construction: Molded plastic 14-spoke design with a flat inner face to suit common drift tyres and foam inserts.
• Use: Best for tyre tuning, cosmetic front replacements, and routine setup experiments on the track.

Installation tips for smooth fitment

Always verify hub adapter compatibility before gluing tyres. For soft drift tyres, seat the bead evenly and apply a small amount of adhesive where needed. While front drift wheels are less sensitive to balance than driven rears, a quick spin check will spot any wobble during slides. Label wheel rotation if you use directional tyres and keep a spare pair for events.

Care and basic setup advice

Remove excess tyre glue with isopropyl alcohol and check spoke edges for any flashing after trimming. Replace foam inserts once they show compression, as worn inserts alter tyre profile and turn-in. For tuning, make measured changes to rear tyre width or compound while keeping the front set consistent to tune overall drift balance.