KC10 Rear Shock Stay & Panhard Rod Mount - CL005 (Kyosho)  [KY-CL005]

KC10 rear mount: shock stay and panhard bracket

This Kyosho CL005 Shock Stay & Panhard Rod Mount is an RC-scale replacement mounting bracket made for the KC10 chassis. It brings the rear shock stay and panhard rod mounting points together into one fitted piece, giving a clear anchor for rear suspension links and a repeatable alignment reference for chassis setup.

Fitment and role are direct: the bracket locates on the KC10 rear subframe mounting area and forms a structural mount for shock bottoms and the panhard rod. Once installed it influences rear suspension geometry and lateral axle position, so it is treated as a chassis tuning component to refine handling balance rather than as a raw power upgrade.

Installation notes: remove rear bodywork and follow normal chassis disassembly to reach the rear mounts, reuse original fasteners where suitable, and confirm alignment and free suspension movement after installation. Check link angles and pivot clearances when reassembling to avoid binding.

Maintenance and tuning advice: inspect the mounting faces for looseness or wear after heavy use, torque fasteners periodically, and use small changes to panhard rod placement and shock lower position to dial roll center and cornering response on practice runs.

Compatibility

Designed specifically for the Kyosho KC10 chassis and intended for KC10-based RC-scale models.