Kyosho CL028 pivot balls are supplied as an 8pcs set sized at 5.8mm for service and replacement on KC10 chassis linkages. These ball joints correspond to the steering and suspension connection points on the KC10 platform and are intended as model-scale, direct-fit components only.
Fit this set to reduce steering play and restore a firmer steering feel that can be lost with worn joints. Inspect ball cups and rod ends for damage before assembly, replace any worn parts, and make sure seating surfaces are clean to preserve correct geometry. Prompt replacement of worn pivot balls helps maintain predictable suspension motion and steering accuracy.
Installation is commonly performed during front-end or suspension servicing; separate the affected linkage, insert the replacement ball into the cup or rod end, then reassemble and check movement for binding. After fitting, verify alignment and adjust thread engagement if necessary to retain full range of motion.
Copyright © 2008-2026 rcjaz.ca All rights reserved
