KC10 Pivot Ball Flange 6.8mm 4pcs - Kyosho CL030  [KY-CL030]

6.8mm flanged pivot balls for KC10

The Kyosho CL030 pivot ball flange is supplied as a pack of four 6.8mm flanged pivot balls made for use on KC10 chassis RC cars. These components serve as direct replacements for flange-type pivot interfaces used in suspension and steering linkages.

The flange design gives a flat mounting surface for knuckles and linkages, which reduces side-to-side play compared with non-flanged versions when seated correctly. Fit replacements to restore tight articulation and preserve steering and suspension geometry after maintenance.

Installation notes: confirm the pivot ball seats correctly in your KC10 steering knuckle or linkage housing, clean mating surfaces before fitting, remove any debris that could stop the flange from seating, and verify the joint moves freely without excessive slop once installed. If multiple pivots show wear, replace the affected pieces to keep handling balanced.

Tuning role: replacing worn pivot balls can tighten up steering feedback and improve suspension response. When you make toe or camber adjustments, ensure pivot interfaces are free from binding so cornering remains predictable.

This 4pcs pivot ball flange pack is intended for KC10 setups that specify 6.8mm flanged pivot balls, and is used to renew linkage points and help maintain consistent handling on scale RC cars.