KC10 Pivot Ball 6.8mm Replacement Set - Kyosho CL029 (8pcs)  [KY-CL029]

KC10 6.8mm Pivot Balls for Steering and Suspension

This Kyosho CL029 pivot ball pack is specified for the KC10 chassis and supplied as a set of 8pcs, sized 6.8mm to match the KC10 pivot geometry. It is a scale RC accessory intended to replace worn ball joints in steering and suspension linkages without altering chassis design.

These parts are offered as replacement components for routine maintenance and part renewal; confirm fit to your KC10 parts before final assembly. They restore the intended pivot seating and help maintain original joint alignment when installed correctly.

Installation is a straightforward mechanical swap: remove the worn pivot balls from the ball cups, fit the 6.8mm units into the matching ball seats, and ensure correct seating and acceptable free play. After installation, cycle the steering and suspension through full travel to check for smooth operation and absence of binding.

Used as consumable wear items, replacing these pivot balls can restore consistent joint geometry and help preserve predictable steering and suspension response during setup checks and regular use.