KC10 Front and Rear Bumper Set - Kyosho CL012  [KY-CL012]

Replacement bumpers for KC10 chassis

This Kyosho CL012 set supplies front and rear bumper pieces made to act as direct replacement parts for the KC10 radio control chassis. The description emphasises practical fitment and service use so you can restore nose and tail protection and basic front/rear geometry after running incidents.

Compatibility covers the KC10 chassis platform only; the pieces are scaled for RC application and intended to mount at the original bumper attachment points. When fitting, check existing mounting points and reuse any factory screws or brackets that remain serviceable, using an appropriately sized hex driver and correct hardware torque to avoid overtightening.

From a setup point of view these bumpers mainly protect the nose and rear during routine running and minor collisions. They do not change suspension or steering geometry on their own but will influence crash behavior and weight distribution when combined with other chassis modifications.

For ongoing maintenance, clean the mounting faces before assembly and inspect for stress cracks after hard impacts; replace the set if deformation prevents proper fit or alignment.