This Kyosho CLB002WG decoration body set is built for RC scale cosmetic upgrades and fits chassis layouts that follow the KC10 mounting pattern. The text concentrates on fitment, mounting points, and practical trimming advice so hobbyists can plan installation accurately.
Compatibility and fitment: the shell is intended to align with KC10-style post locations and clearances. Before fitting, check body post spacing, roof accessories, antenna clearance and wheel travel. If arch or hole adjustments are needed, cut gradually and test-fit repeatedly to avoid removing too much material.
Installation notes: place the shell over the chassis and mark post positions, then use your chassis body posts and clips where possible. Trim from the inside of the shell with fine tools for neat edges. Secure the body with standard body clips or compatible aftermarket clips, and confirm that full suspension travel and steering sweep are unobstructed.
Tuning and use: this decoration set is mainly cosmetic to recreate the Land Cruiser 60 appearance at scale. Differences in airflow and mass versus a stock shell are usually minimal, so focus on clearance and firm mounting to prevent rattles or rubbing during operation.
For restorers and custom builders running KC10-based rigs, the CLB002WG Type2 decoration body is a simple cosmetic upgrade that installs with routine RC practices and introduces little tuning compromise.
Copyright © 2008-2026 rcjaz.ca All rights reserved
