This replacement C-hub is made for the KC10 chassis in RC scale. It positions the hub carrier relative to the lower suspension arm and steering linkage, so correct fit and alignment are needed for predictable steering behaviour.
Use only on KC10-specified models; confirm your chassis code before fitting. The part is a direct-fit replacement to recover steering geometry after wear or impact and to provide a stable base for setup changes during tuning.
Installation notes: remove the wheel and hub carrier assembly, examine fasteners and bushings, transfer any serviceable sealed bearings or shims, and refit using the original mounting points to maintain suspension geometry. Apply the same thread-locking and torque practice used on other KC10 fasteners to avoid misalignment.
Tuning role: replacing a worn or damaged C-hub restores steering response and toe settings to their intended positions, making it a useful spare for maintenance cycles and pre-event checks. It is intended as a chassis-level service item rather than a standalone performance upgrade.
Carry spare C-hubs to reduce downtime during track sessions and to keep KC10 handling consistent.
Copyright © 2008-2026 rcjaz.ca All rights reserved
