Jazrider TAMIYA TT01E/TT01ED Front Upright Knuckle Arms Aluminum Upgrade - JR-TT101-BK - RC Spare Part  [JR-TT101-BK]

Tamiya TT01E / TT01ED Aluminum Front Upright Knuckle Arms (Black)
Price:
CAD$16.31
Brand:
JAZRIDER
Model:
JR-TT101-BK
Condition:
Brand New
Available in shop
Write a review

Stiffer aluminium uprights for TT01E/TT01ED

This replacement suits the TAMIYA TT01E and TT01ED front upright assemblies, offering a black anodized aluminum construction and identified as model JR-TT101-BK. It follows the original mounting geometry so steering pickup points remain in the same position.

Tuning impact: replacing the factory plastic uprights with aluminum reduces flex at the steering pivot and wheel hub, which helps keep toe and camber steadier under load and makes handling adjustments more predictable when refining corner entry and balance.

Installation notes: these knuckle arms are built for the TT01E/TT01ED front upright interface; check screw lengths and bearing seating before final assembly. No additional hardware list is provided here.

How will aluminium uprights change steering behavior?

Aluminum uprights reduce flex at the steering knuckle, which typically sharpens initial steering response and preserves alignment under heavy corner loads; expect a firmer feel compared with plastic parts.

Do I need different screws or bearings to fit these?

They are designed to match the TT01E/TT01ED interfaces, but verify that your existing screws and bearings seat correctly; shorter or longer screws may be required depending on your hub setup.

Will this part affect toe and camber stability?

The stiffer mounting point helps maintain toe and camber under load, reducing unwanted change during hard cornering and offering a more consistent baseline for alignment tuning.

Copyright © 2008-2026 rcjaz.ca All rights reserved