Inferno MP11 Swing Shaft (L=92, 2pcs) - IFW703 by Kyosho  [KY-IFW703]

Overview: Universal swing shaft for MP11

This Kyosho IFW703 universal swing shaft is a replacement drivetrain shaft designed specifically for the Inferno MP11 platform. The shaft measures 92mm and is supplied as a set of 2 pcs to swap out worn or damaged swing shafts in the MP11 drivetrain assembly.

The component is a direct-fit for MP11 units, restoring driveline geometry and reducing end play that appears as shafts age. Use this part strictly as a drivetrain component for RC models; it is not intended for non-RC uses.

Installation notes: check alignment and orientation against the existing MP11 components before final torqueing, inspect axle pins and bearings for wear, and verify smooth rotation of the drivetrain after assembly. The shaft is intended to integrate with MP11 drivetrain layouts and to assist routine maintenance and setup of 1/8-scale electric buggies.

Fit the IFW703 set when replacing worn swing shafts on MP11 cars to preserve drivetrain alignment and predictable handling on club and track runs.