Inferno GT / GTW26-17 2nd Gear 17T - Kyosho IG113-17  [KY-IG113-17]

Kyosho IG113-17 - 2nd Gear(17T/Inferno GT/GTW26-17)
Price:
CAD$0.00
Brand:
Kyosho
Model:
KY-IG113-17
GTIN:
4548565109616
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Replacement second gear for Inferno GT and GTW26-17

The Kyosho IG113-17 second gear is supplied as a like-for-like service part for compatible GT-series gearboxes. It carries a 17T tooth profile and is intended for routine maintenance, repair or tuning when an identical spare is needed.

For installation, experienced hobbyists should remove the gearbox cover, note the existing gear stack orientation, inspect pinion and spur engagement, then swap in the replacement second gear. Check for free rotation and correct mesh, reinstall any split collars or circlips, and torque gearbox screws evenly to avoid distortion. Verify clearance against the motor pinion before finishing reassembly.

On tuning impact: the IG113-17 17T second gear influences intermediate ratio behavior, altering mid-range acceleration and response. Use it with complementary pinion and spur selections to retain drivetrain balance; worn bearings or mismatched tooth counts can cause noise or premature wear, so inspect adjacent bearings and shafts when replacing the gear.

Compatibility

  • Inferno GT
  • GTW26-17

Use this unit as a direct replacement during gearbox servicing or when restoring drivetrain geometry after track use. Always confirm parts compatibility against your chassis manual before fitting.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will this drop straight into the stock gearbox?

In most cases it installs as a direct swap; match the 17T marking and the gear spline to your gearbox layout and confirm mesh and endplay before final assembly.

Any special tools needed to fit the gear?

Basic hand tools suffice: hex drivers, a small pair of pliers for circlips, and a clean workspace. Take care when tightening screws to avoid warping the gearbox halves.

Should I check bearings when replacing this gear?

Yes. Inspect nearby ball bearings for play or roughness and replace any that are worn to preserve gear alignment and avoid rapid wear of the new gear.

Will changing this gear alter vehicle performance?

Altering the second gear tooth count modifies intermediate gearing and can change acceleration and top speed. Always pair changes with matching pinion and spur choices and retest handling after adjustments.

Copyright © 2008-2026 rcjaz.ca All rights reserved