HUDY 101085 Precision Shim Set 0.2mm 0.3mm 0.5mm (4 Pieces)  [HSP-101085]

HUDY 101085 - HUDY Shim For Cutting Tool 0.2 0.3 0.5 (4)
Price:
CAD$11.88
Brand:
HUDY
Model:
HSP-101085
Condition:
Brand New
Write a review
alt="HUDY 101085 - HUDY Shim For Cutting Tool 0.2 0.3 0.5 (4)" title="HUDY 101085 - HUDY Shim For Cutting Tool 0.2 0.3 0.5 (4)"

Shim Set for Fine Lathe Calibration

For RC builders wanting repeatable tool heights on their Hudy Comm Lathe, the HUDY shim set is a simple way to adjust cutting tool clearance. The pack contains four shims and covers 0.2mm, 0.3mm and 0.5mm thicknesses to suit different trimming and turning tasks.

Step Adjustments for Accurate Cutting

Small height changes can make a big difference when finishing chassis or driveline parts. These shims let you dial in precise increments so the cutting tool sits at the correct height for clean, consistent cuts on small RC components.

Made for Lathe Setup and Maintenance

Built to work with the Hudy Comm Lathe setup, the shims are a practical choice for routine maintenance or race day tuning. Use them when swapping tooling or when you need quick, reliable adjustments between runs.
Remark :
Due to limited stock availability, please notice that some HUDY items may have to order from the factory and the ready time is around 8-12 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

What thicknesses come in the kit?

The set contains shims in 0.2mm, 0.3mm and 0.5mm thicknesses, supplied as four pieces to combine as needed.

Can I use these shims with other cutting tools?

They are intended for the Hudy Comm Lathe but can work with similar setups where thin precision shims are accepted between tool and holder. Check clearance before final use.

Any tips for stacking shims?

Stack shims flat and clean, then tighten the tool clamp evenly. Start with the thinnest shim and build up until you reach the desired height to avoid tool tilt.

Copyright © 2008-2026 rcjaz.ca All rights reserved