This replacement alloy front/rear C-Hub is made for HPI Savage platform vehicles and forms the steering knuckle mounting point in the suspension assembly. The part is presented as an aftermarket replacement to repair damaged C-Hubs or refresh worn steering linkages without implying factory OEM fitment.
Manufactured from aluminium alloy, the unit accepts standard king pins and is supplied with the small fasteners needed to secure the hub to steering arms and axle mounts. An alloy C-Hub can help retain alignment under load and reduce play compared with heavily worn plastic components.
Installation notes: check king pin fit and e-clip seating, torque fasteners to a serviceable tightness that matches your chassis hardware, and verify wheel alignment and toe after installation. Avoid over-tightening pivot screws to prevent binding in the steering assembly.
Replace worn front or rear knuckles on supported Savage variants with this GPM alloy C-Hub, carry out alignment checks after fitment, and keep spare king pins and e-clips for routine maintenance.
Copyright © 2008-2026 rcjaz.ca All rights reserved
