These alloy front and rear steering blocks are made as direct-fit alternatives to the factory plastic carriers for HPI Savage platforms. The metal parts are intended to hold steering geometry more consistently under load and they come with the screws and washers needed to fit to the original mounting points.
The set is intended for scale replacement, maintenance or light chassis tuning. The write up emphasises correct fitment, assembly care and the effect of a stiffer carrier on linkage movement rather than performance claims.
Replace worn plastic carriers with these alloy blocks when you want more repeatable steering geometry; always check fastener torque and steering linkage alignment after installation to keep steering response predictable.
Copyright © 2008-2026 rcjaz.ca All rights reserved