This aluminum alloy skid plate is engineered as an RC-scale replacement and upgrade for the HPI Savage Nitro off-road series, providing a compact protective panel that mounts under the chassis to guard against rocks and trail debris.
The purple finish helps with part identification while the alloy construction prioritizes wear resistance and increases underside protection without adding excessive bulk.
Compatibility is limited to the stated HPI Savage Nitro off-road series. The plate is intended to use the series' factory mounting points and to fit the vehicle’s existing underbody layout without modifying major structural components.
Installation requires aligning the plate to the factory mounting positions and securing it with the vehicle’s original attachment points or the hardware supplied by the seller. No changes to the motor, ESC, or suspension are needed for fitment, but verify fit on your specific Savage variant before final installation.
As part of a setup this plate protects the lower chassis from impacts and abrasion, influences ground-scrape characteristics due to its low profile, and adds a small amount of mass low on the chassis which can subtly change handling—use short test runs to assess balance and response.
A practical alloy underbody protector for HPI Savage Nitro models, suited to hobby off-road use where compact, durable chassis protection is required.
Copyright © 2008-2026 rcjaz.ca All rights reserved
