HPI Savage 21 Titanium Hinge Pin Set TSAV1101 by GPM  [TSAV1101]

Replacement titanium hinge pins built for Savage 21

This hinge pin kit fits the HPI Savage 21 and provides durable titanium pins paired with E-clips to replace worn or bent factory hardware. The set is sized for standard hinge locations and intended as a direct maintenance or upgrade item for hobby use.

Fitting is simple: remove the old pins from the axle or arm, place the new titanium pins in the original holes, then secure each pin with the supplied E-clip. Basic hand tools such as needle-nose pliers or a small E-clip tool are all that is required to install or remove the clips.

As a tuning option these low-mass titanium pins reduce pivot play and help retain alignment under higher loads. Titanium offers a good strength-to-weight ratio and improved corrosion resistance versus ordinary steel pins, helping keep suspension geometry consistent over repeated runs.

Use these pins to restore secure pivot points on an HPI Savage 21 or as a light, corrosion resistant upgrade where original pins have worn or bent.