HPI Savage 21 Steel Hinge Pin Set SSAV1101 by GPM  [SSAV1101]

Replacement hinge pins for Savage 21

This aftermarket kit provides steel hinge pins finished with E-clips for HPI Savage 21 models, listed as SSAV1101. The pack is supplied as six pairs, giving matched pins and retaining clips to replace worn or damaged pivot hardware at suspension and link attachment points.

These pins act as pivot points for suspension arms and link mounts; swapping in straight or fatigued pins restores alignment and reduces free play in steering and suspension travel. Steel construction improves resistance to bending versus softer stock pins, while E-clips allow quick removal for routine service.

Installation is a direct pin-for-pin swap: remove the old clip and pin, slide the new pin into the locating holes, then seat the supplied E-clip fully into the groove. After fitting, check that the suspension moves freely and there is no binding at the pivot. Carry spare E-clips and pins as common wear items for aggressive off-road sessions.