HPI Savage 21 Front and Rear Steering Block Set Alloy-7075 - SAV1021H by GPM  [SAV1021H]

Steering Block Upgrade Summary

This steering block set is an alloy upgrade made for HPI Savage 21 scale models. The metal replacements take the place of the stock plastic blocks at both front and rear positions and include the matching screws and washers to make the swap-out straightforward. The Alloy-7075 construction focuses on greater rigidity and wear resistance while preserving the original mounting locations.

Fit these blocks when you need firmer steering geometry under heavier loads or during setup work where reduced hub flex helps tuning. The metal blocks deliver a more consistent feedback path from the servo through the linkage, aiding adjustments to toe, camber, and steering throw on both track and field sessions.

This alloy steering block set suits hobbyists aiming to cut steering flex and extend component life on HPI Savage 21 rigs; installation uses the vehicle's stock attachment points and supports routine tuning changes.