HPI Savage 21 Alloy-7075 Front and Rear Lower Arm Set SAV1055H by GPM  [SAV1055H]

HPI Savage 21 Alloy-7075 Front/Rear Lower Arm With Pins & Screws & E-clips - 1pr set - GPM SAV1055H
Price:
CAD$43.31
Brand:
GPM
Model:
SAV1055H
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Durable alloy lower arms for Savage 21

The SAV1055H lower arm set is an aftermarket Alloy-7075 replacement engineered for HPI Savage 21 models. Supplied as a 1pr set, it includes front and rear lower arms together with the pins, screws and E-clips needed to swap out the factory plastic arms.

These components are intended for RC suspension use to correct worn steering geometry or to reduce flex at the lower pivot when tuning handling. Fitment follows standard lower-arm removal and refit procedures on the Savage 21 chassis, using the supplied pins and E-clips to secure the arms into the existing mounts.

Specifications

  • Item Front/Rear lower arm set (1pr) with pins, screws and E-clips
  • Material Alloy-7075
  • Model Number SAV1055H
  • Compatibility HPI Savage 21

Fit these alloy lower arms to replace broken plastic links or to cut suspension compliance; confirm correct orientation, seat the E-clips fully and recheck fasteners after an initial run to ensure reliable operation.

Will these arms fit stock Savage 21 suspension mounts?

Yes. The set is made to match Savage 21 mounting points and uses the included pins and E-clips for direct installation into the existing suspension brackets.

Can I use the stock hardware or do I need the supplied parts?

The kit includes pins, screws and E-clips for convenience; you can reuse serviceable factory hardware but using the supplied items ensures correct fit and thread engagement.

How does Alloy-7075 affect handling compared with plastic?

Alloy-7075 reduces flex at the lower pivot points, giving crisper steering response and more consistent geometry under load compared with standard plastic arms.

Are any special tools required to fit these arms?

No special tools are required; common hex drivers and pliers for E-clips are sufficient for removal and refit of the lower arms.

What maintenance should I perform after installation?

After fitting, check suspension alignment, verify E-clip seating and re-torque hardware after a short test run; inspect pivot pins periodically for wear.

Copyright © 2008-2026 rcjaz.ca All rights reserved