HPI Racing SAVAGE XL FLUX Aluminium Wheel Hex Claw with Brake Disk SAF1010DISK by GPM  [SAF1010DISK]

Price:
CAD$40.61
Brand:
GPM
Model:
SAF1010DISK
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Aluminium wheel hex claw with brake-disk detail

This aluminium wheel hex claw with integrated brake-disk is a direct-fit RC-scale spare made for the HPI Racing SAVAGE XL FLUX, supplied as a 2pcs set. Machined aluminium gives torsional stiffness for secure wheel mounting and a visible brake-disk detail for a more authentic scale look, intended for hobby-grade tuning and repair on model vehicles only.

Installation is straightforward on compatible hubs using a correct-size hex driver and the vehicle's original wheel hardware; the part acts as a mechanical wheel-mount interface rather than a working brake. When swapping in aluminium claws in place of plastic hexes, expect changes in load transfer to the axle, so verify wheel runout and hub clamp torque during setup.

Tuning role: this component is chosen by hobbyists wanting greater durability and improved scale appearance on off-road buggies and stadium trucks, and it can slightly affect unsprung mass and wheel balance. Inspect fastener torque and mating faces after initial runs to detect any unusual wear.

Specifications

  • Item: Aluminium Wheel Hex Claw With Brake Disk, 2pcs set
  • Material: Aluminium
  • Model Number: SAF1010DISK
  • Compatibility: HPI Racing SAVAGE XL FLUX

This aluminium hex claw set is a durable replacement and a visual upgrade for the SAVAGE XL FLUX, suitable for maintenance and modest, performance-focused tuning on RC models.

Do these mount to stock SAVAGE XL FLUX hubs?

They are designed to match the stock SAVAGE XL FLUX hex interface; check the specific hub face and thread fit before final installation.

What tools should I use to fit the hex claws?

Use the correct-size hex driver for the wheel nuts and tighten with a consistent, torque-aware approach; avoid over-tightening to prevent bearing preload issues.

Will aluminium change the handling?

Switching to aluminium can alter unsprung mass and wheel balance a little; test the vehicle and adjust suspension settings or wheel balance if you notice handling changes.

Are additional studs or bearings included?

The set contains the aluminium hex claws with brake-disk detail only; wheel studs, bearings, and extra hardware are not included unless the seller lists them.

How should I maintain these parts?

After the first runs inspect mating surfaces and fasteners, clean any debris, and replace parts showing thread damage or deformation to maintain reliable fitment.

Copyright © 2008-2026 rcjaz.ca All rights reserved