HPI Bullet Rear Hub Carriers Orange Alloy for BULLET 3.0 MT and ST - BUL-18009-OR by Jazrider  [BUL-18009-OR]

Alloy Rear Hub Carriers for HPI Bullet

This BUL-18009-OR rear hub carrier is an RC-scale alloy unit engineered to match the HPI Bullet wheel and suspension layout for BULLET 3.0 MT and ST models. As a direct replacement for the plastic carrier, it stiffens the rear hub mounting without changing the chassis geometry.

Material and role: finished in orange alloy, the carrier locates the wheel hub and takes suspension loads. The stiffer construction increases local rear-end rigidity and alters suspension feedback during acceleration, braking, and cornering, so expect a modest change in handling compared with stock plastic parts.

Installation notes: this carrier installs at the original rear hub location and uses the existing bearings and mounting screws from the Bullet 3.0 rear assembly. During fitment check bearing seating and wheel-hex alignment with the driveshaft; tighten mounting screws to the vehicle's recommended torque and verify there is no binding.

Tuning considerations: alloy carriers reduce local flex and can modify camber and toe behavior under heavy inputs. When fitting this part, adjust shock preload, arm geometry, and bearing play to rebalance handling rather than treating the carrier as a standalone fix.