HPI Bullet Front Suspension Arms Upgrade for Bullet 3.0 MT and ST - BUL-18003-GU by Jazrider  [BUL-18003-GU]

Direct-fit front arms for HPI Bullet

These front suspension arms are a scale replacement for HPI Bullet models and are supplied as model BUL-18003-GU. Built in gunmetal alloy for hobby use, they install into Bullet 3.0 MT and ST front layouts without changing the original chassis geometry.

Use this set when you want a direct-fit spare or a simple upgrade to reduce flex versus standard plastic arms. Installation follows conventional front-arm removal steps: remove the hub and pivot pins, fit the new arms, reinstall existing hardware and check free suspension travel and full steering range. No special tools beyond common hobby hex drivers are required.

On the setup side the gunmetal option helps keep alignment after hard impacts and aggressive cornering on nitro off-road vehicles. Expect little to no change in ride height; adjust shocks and toe/inset if further handling tuning is needed.