HPI Bullet Front Chassis Brace Orange Alloy - BUL-18004-OR by JAZRIDER  [BUL-18004-OR]

Stiffen the front on HPI Bullet models

The BUL-18004-OR front chassis brace is an alloy reinforcement made to replace the standard front brace on HPI Bullet vehicles. It increases front-end rigidity and reduces flex where the front suspension meets the chassis, helping drivers sharpen steering response and balance without changing suspension pick-up points.

This brace is intended for HPI Bullet 3.0 MT and ST nitro variants; confirm your Bullet chassis version before fitting. Finished in orange anodised alloy, it offers a low-profile, dimensionally stable component that lines up with the existing mounting points around the front bulkhead and shock tower.

Fitting is straightforward for hobbyists used to front-end disassembly: remove the stock brace, align the alloy unit with the factory holes, and reuse the original fasteners for direct fitment. No changes to servo, ESC, or motor placement are expected since the brace modifies structural stiffness rather than drivetrain layout.

As a tuning option, the brace adjusts front-end stiffness rather than suspension geometry: fit it when you need crisper turn-in or less chassis flex under braking and acceleration on 1/8-scale nitro tracks. It complements standard Bullet setup changes such as anti-roll bar adjustments or shock valving when refining on-track behavior.