HPI Bullet Front Chassis Brace for Bullet 3.0 MT/ST - BUL-18004-GU by Jazrider  [BUL-18004-GU]

HPI Bullet - Gunmetal Alloy Front Chassis Brace
Price:
CAD$14.68
Brand:
JAZRIDER
Model:
BUL-18004-GU
Condition:
Brand New
Write a review

Front brace upgrade for HPI Bullet

This RC-scale front chassis brace is built for the HPI Bullet range and is supplied as model BUL-18004-GU by JAZRIDER. The gunmetal alloy component adds concentrated stiffness to the front chassis to help drivers fine-tune handling and balance.

The brace attaches to the existing front chassis mounting points and is designed to work with the Bullet 3.0 MT and ST nitro layout without changing core geometry. Its tuning role is focused and measured: increase front-end stiffness to influence turn-in and front grip during setup changes.

Installation notes: this is an upgrade front brace compatible with the listed Bullet variants; confirm alignment with your chassis mounting points before fitting. Treat the part as a structural hop-up for tuning, not a full chassis replacement.

How do I fit the BUL-18004-GU to my Bullet?

The brace mounts to the stock front chassis attachment points using the original hardware in most cases. Ensure the mounting holes align and tighten to the recommended torque.

Will installing this brace change my chassis geometry?

No major geometry changes are expected; the part is designed to bolt on without altering basic layout. It increases stiffness rather than shifting suspension pick points.

Is this a full chassis or only a front brace?

This item is a front chassis brace only. It is intended as a tuning hop-up and does not replace the complete chassis assembly.

Copyright © 2008-2026 rcjaz.ca All rights reserved