HPI Bullet Front and Rear Alloy Shock Towers - BUL-18005-OR by Jazrider  [BUL-18005-OR]

Front and rear alloy towers

This RC-scale front and rear shock tower set is machined from alloy with an orange finish, supplied as 1 pcs for HPI Bullet models. It provides fixed mounting points for shocks and includes an integrated body mount interface for suspension tuning and shell attachment.

The item is intended to replace stock plastic towers to deliver firmer mounting and repeatable alignment during setup. Use the factory hardware where suitable and check clearance to the body and full suspension travel before completing assembly. Fit the part to the existing hole pattern on compatible Bullet chassis to keep the stock geometry intact.

Use these towers when fine-tuning suspension response or when you need a secure body shell fixing during runs and maintenance. As an accessory, it pairs with upgraded shocks, springs, and hardware rather than changing electronics or drivetrain components.