HPI Bullet FLUX Steering Upgrade - Orange Alloy Steering Assembly BUL-18002-OR by Jazrider  [BUL-18002-OR]

Orange Alloy Steering Set for Bullet FLUX

This RC-scale steering assembly is finished in orange alloy and designed for the HPI Bullet FLUX chassis. It replaces stock plastic steering parts and provides a firmer linkage with integrated bearing support to cut play. This component is a chassis-level hop-up focused on steering precision and linkage stability rather than powertrain output.

Fitting instructions

• Compare the existing linkage and mounting points on Bullet FLUX MT or ST, remove the original steering knuckles, and install the alloy assembly in the same locations.
• Where possible, reuse compatible mounting hardware; check clearance with your servo horn and tie-rods before the final torque step.
• After fitting, centre the steering and confirm toe settings and free play to guarantee predictable steering response.

Setup impact

• Alloy knuckles with bearings reduce slop at the steering pivot, improving repeatability for track runs or backyard testing.
• Adjust servo endpoints and linkage geometry after installation to balance steering speed and mid-corner stability.