HPI Bullet Alloy Front/Rear Shock Tower Set - BUL-18005-GU by Jazrider  [BUL-18005-GU]

Gunmetal alloy shock tower for HPI Bullet

This RC-scale alloy front/rear shock tower set is crafted for the HPI Bullet chassis and supplied as 1 pcs in a gunmetal finish. The single-piece construction combines body mount points and delivers a firmer anchoring point for shocks and body posts versus stock plastic towers.

The component increases rigidity around suspension mounting areas and stabilises body mounts during hard cornering or impacts. In tuning terms it changes how the suspension transmits load through the tower, helping keep consistent shock geometry under load.

Installation is simple for experienced builders: the tower replaces the original front and rear shock tower positions using the existing chassis mounting holes, typically reusing the same screws and body posts. When fitting, hand-start fasteners and confirm shock shaft and body post alignment before final torque to prevent binding. No extra hardware or tools are included unless noted by the retailer.