HPI Bullet 3.0 MT/ST Spring Steel Tie Rod Set 7pc BMT160ST by GPM  [BMT160ST]

HPI Bullet 3.0 Mt And St (Nitro Engines) Spring Steel Tie Rod With Plastic Ends - 7pcs set - GPM BMT160ST
Price:
CAD$30.25
Brand:
GPM
Model:
BMT160ST
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Replacement tie rod pack for HPI Bullet 3.0 MT and ST

This direct-fit aftermarket tie rod kit fits HPI Bullet 3.0 MT and ST nitro chassis and provides straightforward steering and suspension linkage replacement. The rods use spring steel for flex resistance and lightweight plastic end fittings to keep pivot play low while preserving thread engagement.

The kit includes seven pieces to swap out worn steering links or suspension connectors commonly found on nitro monster truck and stadium truck setups. Components restore the original linkage geometry and allow toe adjustments without changing stock chassis layouts.

Installation tips: check ball sockets and thread condition before assembly, replace any worn bearings or ends, and set rod lengths to match original toe and steering geometry. Adjust in small steps and cycle the steering and suspension to ensure free movement and no binding.

Specifications

  • Item: Spring steel tie rod with plastic ends - 7pcs set
  • Material: Spring steel, plastic end fittings
  • Model Number: GPM BMT160ST
  • Compatibility: HPI Bullet 3.0 Mt and St (Nitro Engines)

Use this set to replace fatigued linkages and regain consistent steering feel; always verify fit and alignment after installation and work the suspension through its travel to confirm smooth operation.

Will these fit the standard HPI Bullet 3.0 MT steering assembly?

Yes, this aftermarket set is made as a direct-fit replacement for the steering link locations on HPI Bullet 3.0 MT and ST nitro chassis.

How should I check for worn plastic end fittings?

Inspect each socket for play and visible deformation; any looseness at the ball joint or threaded connection indicates the end should be replaced to maintain steering precision.

Can I reuse old rod lengths when fitting these?

Yes, set each new rod to the same threaded length as the originals and confirm toe settings before final tightening to preserve handling balance.

Are these parts suitable for high-impact bashing?

Spring steel gives good fatigue resistance, but plastic end fittings can wear under heavy impact; inspect after hard runs and consider metal ends if you need heavier duty.

What is the model code when ordering replacements?

Order using the model number listed in the specifications: GPM BMT160ST.

Copyright © 2008-2026 rcjaz.ca All rights reserved