This graphite radio tray is an RC-scale replacement part produced for the HPI Bullet 3.0 MT and ST platforms fitted with Nitro engines. It provides a dedicated mounting surface for the receiver, servo and associated small electronics to keep wiring tidy and components secured inside the chassis layout common to these models.
The plate is finished in blue over a graphite substrate and is designed to sit in the vehicle radio bay using the original mounting pattern for Bullet 3.0 MT and ST layouts. The intent is a stiff, low-profile panel that matches typical 1/10 off-road component positions without adding unnecessary bulk.
Installation notes: the tray is supplied as a single-piece panel and should be attached using the chassis existing screw points where compatible. Route antenna and power leads along the model's stock paths and verify clearance around the servo and the fuel tank on Nitro-equipped Bullet 3.0 MT/ST variants before completing final tightening.
Setup and maintenance use: fit this tray to keep radio gear in a consistent location during tuning and track work, and to make receiver or servo swaps easier without changing the primary chassis geometry.
Copyright © 2008-2026 rcjaz.ca All rights reserved
