This adjustable front tie rod is a direct-fit RC part for HPI Bullet 3.0 MT and ST nitro models and is supplied as one pair. The main shaft is spring steel while the end fittings are alloy to protect threads at the connection points, and a 4mm anti cross-thread detail reduces the risk of stripped threads. The assembly is adjustable from 73mm to 80mm for straightforward steering geometry tweaks.
As a steering link, the tie rod helps set toe and removes play from worn front linkage components. Its adjustable length makes small toe-in or toe-out adjustments quick without needing fixed-length replacements, useful when tuning handling or adapting to different surface grip.
Fitting tips: this part is intended for the specified HPI chassis. When installing, align the threads and ensure the alloy ends seat flush at the steering knuckle and bell crank. Match both sides for equal length and travel, and recheck thread engagement after initial runs to spot any loosening or wear.
Copyright © 2008-2026 rcjaz.ca All rights reserved
