HPI Bullet 3.0 MT/ST Front and Rear Alloy Shock Tower Upgrade - BUL-18005-BK by Jazrider  [BUL-18005-BK]

Machined alloy shock towers

This RC-scale alloy front and rear shock tower set includes an integrated body mount and is supplied as one piece. The part is designed for HPI Bullet platform models listed as Bullet 3.0 MT and ST in published parts listings. Made from machined alloy, the towers replace the stock plastic mounts to give a firmer anchor for the shock tops and the body mount while keeping weight down.

The component secures the upper end of the suspension assembly, helps preserve consistent shock geometry under load, and provides a solid anchor for the body mount. Before fitting, confirm your chassis uses the Bullet 3.0 layout and that the mounting hole pattern matches. Follow standard RC maintenance procedures when removing OEM parts and fitting alloy replacements to avoid damaging threads or surrounding hardware.

Installation notes: this accessory installs at the factory shock tower locations and uses the vehicle's original mounting points and hardware unless your chassis documentation specifies alternate fasteners. Because a stiffer mounting surface can slightly alter shock response, re-check ride height and damping after installation.