HPI Bullet 3.0 MT and ST Graphite Radio Mount - GBMT014MC by GPM  [GBMT014MC]

Graphite radio mount for HPI Bullet 3.0 chassis

This graphite radio tray is an aftermarket replacement part for the HPI Bullet 3.0 MT and ST nitro models. It provides a stable mounting platform for receiver, servo and adjacent electronics while helping keep wiring neat and low profile. The text below covers compatibility, installation tips and how the part fits into chassis setup and tuning.

Compatibility and role: the tray replaces the stock radio platform on Bullet 3.0 MT and ST nitro chassis to deliver a firmer, lower-profile mounting surface. A stiffer tray helps prevent unwanted movement of servo leads and the receiver during aggressive driving or big landings, which can otherwise affect steering response and radio reliability.

Installation notes: the tray is intended to use the original tray mounting points on the Bullet 3.0 chassis so fitting normally requires the existing screw locations and hardware. Confirm alignment and screw length before final tightening, route antenna and servo leads to avoid pinching, and ensure the tray does not interfere with fuel tank or exhaust routing on nitro setups.

Tuning considerations: installing a graphite tray is part of a chassis stiffness approach and can slightly change local flex compared with the stock plastic tray. After fitting, check radio and servo stability first, then evaluate suspension or weight distribution adjustments if handling shifts.