HPI Bullet 3.0 MT and ST Alloy Front Suspension Arm BMT055 by GPM  [BMT055]

Alloy front arm for HPI Bullet front end

This alloy front suspension arm is made for RC-scale service on HPI Bullet 3.0 MT and ST chassis. It replaces the factory front arm and is intended for routine front-end maintenance, repair, or setup adjustments. The item is supplied as a 1pr set aimed at hobby-grade nitro buggy use.

Fitting the arm needs basic RC tools like hex drivers and common hardware; original mounting pins and ball studs are normally reused unless they show damage. The alloy construction raises structural stiffness versus plastic arms, which can alter steering feel and suspension response, so plan modest setup tweaks after installation.

The alloy front suspension arm is an RC replacement part targeted at hobbyists who need a tougher front arm for the HPI Bullet 3.0 MT and ST chassis. Use it for replacing damaged arms or for changing front-end rigidity during suspension setup, and double-check fitment with your steering links and mount hardware.