Hot Bodies Cyclone Rear Stabilizer CY-26/R Machined Aluminium for Sport and Racing by 3Racing  [CY-26/R]

Rear stabiliser upgrade for Cyclone

This machined aluminium rear stabiliser is a tuning component made for the Hot Bodies Cyclone Sport and Racing versions. It replaces softer stock links to give a firmer connection between rear suspension points, helping drivers tune chassis roll without altering spring or anti-roll bar geometry.

Installation uses the Cyclone's existing rear stabiliser mounting locations and the vehicle's original hardware in most cases. No cutting or chassis modification is normally required with the specified Sport and Racing versions, but check screw engagement and local clearances before finalising the fitment.

From a setup perspective the stabiliser increases rear roll stiffness and changes yaw behaviour: higher stiffness can reduce squat and sharpen turn-in, while a softer link tends to increase rear compliance and traction on low-grip surfaces. Make small changes and run test laps to find the best compromise between rotation and mid-corner grip.