Hot Bodies Cyclone Front Stabilizer CY-26/F, Machined Aluminium by 3Racing  [CY-26/F]

Fine front roll tuning with CY-26/F

This machined aluminium front stabilizer is a direct-fit upgrade for Hot Bodies Cyclone Sport and Racing versions. It replaces the factory front anti-roll component to alter front-end roll stiffness and sharpen weight transfer through turns.

Manufactured from machined aluminium for consistent stiffness and dimensional accuracy, the CY-26/F adds controlled roll resistance ahead of the front suspension without changing suspension geometry. It is tailored for 1/10 electric on-road setups where small adjustments to front roll stiffness help refine steering balance and tyre load distribution.

Fitment is straightforward: remove the stock stabilizer and install this unit using the Cyclone's existing mounting points. Standard hex drivers are sufficient; verify screw torque and correct alignment after installation. Once fitted, confirm full suspension travel and check any adjustable swaybar end-link lengths on your chassis.

Tuning tips: raising front stabilizer stiffness reduces roll and can quicken turn-in while possibly increasing understeer at higher speed. Lowering stiffness gives more front compliance and can improve bite on low-traction surfaces. Make incremental changes and test on the same track surface to judge effect.