Hot Bodies Cyclone Front Bumper Stiffener CY-28/WO - On-road Graphite by 3Racing  [CY-28/WO]

Hot Bodies Cyclone Sport Version /Racing Version Graphite Bumper Stiffener - 3Racing CY-28/WO
Price:
CAD$11.52
Brand:
3Racing
Model:
CY-28/WO
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Front bumper graphite reinforcement

This 3Racing CY-28/WO graphite bumper stiffener is a single-piece reinforcement made to fit Hot Bodies Cyclone Sport and Racing front bumpers, letting you increase nose stiffness without changing the bumper geometry.

Installation is straightforward for anyone used to 1/10 touring car work: remove the stock bumper fasteners, place the graphite stiffener over the existing mount points, then secure with the chassis' standard screws. No special tools or permanent modifications are needed.

On-track tuning notes: added bumper stiffness shifts impact absorption and front feedback, which can sharpen turn-in and alter mid-corner balance. Use the stiffener alongside tyre selection, spring rate changes, and anti-roll adjustments for controlled handling evolution.

Will the CY-28/WO fit both Sport and Racing Cyclone layouts?

Yes. The CY-28/WO is designed to align with the stock front bumper mount points on both Sport and Racing versions, but check your bumper layout before final tightening.

Do I need different screws or hardware to install it?

In most cases the stiffener uses the chassis' existing fasteners. Use standard hobby drivers and reuse stock hardware where possible, checking fit before torquing up.

What handling changes should I expect after fitting?

Expect a firmer front response and altered impact absorption that can improve turn-in precision but may reduce low-speed compliance; tune in small steps to judge effects.

Copyright © 2008-2026 rcjaz.ca All rights reserved