Hobbywing 80020530 - FlyFun 100A HV OPTO V4 ESC High-Voltage Aircraft Controller  [HW-80020530]

HOBBYWING FlyFun 100A HV OPTO V4 - 80020530
Price:
CAD$218.09
Brand:
Hobbywing
Model:
HW-80020530
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Peak flight reliability with Hobbywing 80020530 - FlyFun 100A HV OPTO V4 ESC

The Hobbywing FlyFun 100A HV OPTO V4 ESC is built for committed RC pilots who need steady power delivery and dependable current handling. Using imported components and a low-impedance PCB layout, this ESC maintains stable performance under sustained loads. It suits a range of airframes from fixed-wing models to multirotors, and its settings are accessible through the LED program card for straightforward tuning.

Comprehensive protection for long session use

Key safeguards include abnormal input voltage detection, thermal protection, throttle signal loss protection, and low voltage cutoff to protect both the ESC and your pack. These protections help extend service life and reduce the risk of in-flight failures when flying demanding setups.

Specifications

  • Type: Brushless (BL)
  • Voltage: High Voltage (HV)
  • Continuous/Peak Current: 100A/120A
  • Input: 5-12S LiPo
  • BEC Output: No
  • Output Wires: Blue-12AWG-100mm×3
  • Input Connectors: No
  • Output Connectors: No
  • ESC Programming via Transmitter: Supported
  • LED Program Card: Supported
  • LED Program Box: Not Supported
  • LCD Program Box: Not Supported
  • WiFi Module: Not Supported
  • Program Port: Separate Program Wire
  • Firmware Upgrade: Not Supported
  • Size: 88.0x55.0x18.0mm
  • Weight: 112g

For hobbyists upgrading power systems, the FlyFun 100A HV OPTO V4 delivers a practical mix of durability and programmability in a compact package.

This ESC works well in fixed-wing models, helicopters, and multirotor craft provided the motor and battery are within the ESCs current and voltage ratings.
You can program parameters using the included LED program card or via transmitter programming through the program wire, depending on your setup.
No, the FlyFun 100A HV OPTO V4 does not include a BEC output, so a separate power source for servos or receiver is required if needed.

Copyright © 2008-2026 rcjaz.ca All rights reserved