This adjust rod is an RC-scale threaded link intended for linkage and trim work where an M2 thread and 115mm length are needed. The item is supplied as a single threaded rod identified by its model code and is used as a basic control linkage component for helicopters and other small models.
As a functional part, the adjust rod allows length adjustment between rod ends, ball links, or clevis connectors. Install by engaging the M2 threads into suitable rod ends or link blocks, ensure adequate thread engagement, and cycle the control through its full range to check for any binding.
During setup, use the rod to fine-tune neutral positions and control throw before setting servo endpoints and mechanical limits. Inspect thread condition and connections regularly as part of routine maintenance on control linkages.
Copyright © 2008-2026 rcjaz.ca All rights reserved
