Hirobo HI2511026 Cross Member M3 x 82 for Helicopter General Parts  [HI2511026]

This HIROBO cross member is an RC-scale structural part identified by the model code HI2511026 and the M3 x 82 sizing in its name. It serves as a spare or replacement connector in helicopter general parts, providing a rigid link between mounting points in a rotorcraft frame.

Design purpose: the component keeps correct spacing and alignment of adjoining parts, helping to maintain the intended airframe geometry rather than changing flight handling. Fit it where a straight, fixed connector is required to transfer loads between two fixed points in an RC helicopter structure.

Installation notes: because the model designation includes M3 x 82, fasten the cross member using M3 hardware of suitable length for your mounting pattern, make sure mating surfaces sit flush, and check alignment before final tightening. Avoid excessive torque to prevent thread damage, and inspect attachment points routinely for any play.

Tuning and maintenance: this piece contributes to chassis rigidity and will influence how the assembly feels under load; small differences in connector length or placement change frame stiffness. Replace if you find bends, cracks, or persistent looseness, and recheck fasteners after initial flights following any service.