Hirobo HI2509002 Needle Pin 2 x 8.8 for Helicopter Linkage  [HI2509002]

Compact needle pin for helicopter control linkages

This Hirobo needle pin HI2509002 is an RC-scale replacement pin intended for general helicopter parts where a compact, straight pin is required to secure linkage joints and control rods. The product name specifies the usable dimension, allowing hobbyists to confirm fit against existing linkage hardware.

Installation is simple: line up the control rod or ball-link eye with the mounting hole, pass the needle pin through the matching parts, and secure with the original clip or retainer supplied with your model. The pin functions as a basic pivot that preserves alignment during initial setup and routine trimming.

For maintenance and setup tasks this needle pin is a low-complexity item that helps maintain precise control geometry—replace it when pivot wear creates slop, and recheck retention after any control-system adjustments. Always verify the 2 x 8.8 dimension matches your helicopter linkages before long-term use.